Honda S2000 phone bracket installation guide
Honda S2000 Phone bracket Installation Guide
✅ What You’ll Need:
• Phillips screwdriver
• Craft/scalpel knife
• 2mm Allen key
Step-by-Step Instructions:
1. Lift the cluster surround
• Remove the two screws above the instrument cluster.
• Gently lift the HVAC (air-conditioning control panel) side of the cluster surround.
• Trim the dashboard lip behind the surround trim as shown with the red line on the picture.
2. Secure the bracket d place the phone bracket over the screw hole.
• Reattach the phone bracket with the same screw.
• This is also an opportunity to route a very thin USB cable through the support leg.
Route the USB cable through the cutout in the phone bracket behind the cluster trim
3. Finish the installation
• Push the cluster surround trim back into place and reinstall the two screws
above the instrument cluster that you removed in Step 1.
• Check that the bracket is securely in place. If the support leg is putting
force on the bracket and lifting the cluster surround, loosen the screw and
move the support leg slightly away from the cluster surround.
• If the support leg is not touching the dashboard, move the leg slightly
towards the cluster surround trim.
Useful links: UGREEN 15W Wireless Car Mount Charger, Qi2 MagSafe Compatible Charging, Air Vent Magnetic Charger https://www.amazon.co.uk/dp/B0D12GJJ9S
Thin USB cable: CY USB-C Type C to USB-C Ultra Slim Flat Power Angled Connector 65W Fast Charge for Laptop Tablet Phone (20cm) https://www.amazon.co.uk/dp/B0FB48FVYZ
