Honda S2000 52mm Gauge Pod - Button Placement

52mm Size gauge pod specially designed for Honda S2000

The design has been carefully crafted to respect the curves and design flow of the S2000 dash board, these pods might look simple, however they are packed with plenty of features.

Fitting these pods is very straight forward process as they fit perfectly to the slot where usually the head light washer or fog light buttons are, then secure with back plate and provided set of screws and washers to hold the gauge securely under all conditions.

Available either just as plain simple pods with just the fixing plates or with selection of end caps to give the pod the ultimate finish look.

The end cap is held by 4 magnets and it just slides in, the process couldn't be made simpler and magnets are holding the end plate nicely and securely in place.

Gauges with the end cap also comes with 1mm rubber gasket you can chose to use it or not, entirely up to you.

Another included rubber gasket is made to fit between the gauge and the pod body, to give an extra grip.

Wiring slides right through the gauge leg and there is slot made specially to allow wires to be routed next to the gauge as they leave the wire channel.

Depends on your gauge depth you can chode from two end cap sizes:

Shallow - Gauges up to 39mm deep

Deep - Gauges up to 50mm deep

You need to measure the gauge to make sure it fits your selected end cap, please take the length of the screws, rods or other fixings and connectors to count while calculating the gauge depth.

If you want to fit non standard gauge we can provide customized top for the gauge that might need to be glued to the gauge body.